Walchem WebMaster Manual de usuario descargar pdf (Pagina 3)

A drawing of wiring the PosiFlow to the EW-Y pump is below:

Looking at the back of the connector, the pin layout is the same as on the back

of the pump – and while the connector does have tiny numbers molded in next

to the screws, it is usually easier to put the connector onto the pump and then

wire to the pins based on location as shown above and in the manual.

The PosiFlow cable is supplied with fork terminals and when wiring to the

EW-Y connector, they will need to be cut off short and wired as shown.

b. Programming the EW-Y pump for use with the PosiFlow sensor:

The PosiFlow Sensor program is turned OFF by default and will have to be

turned on. This can be done with the following steps:

EW-Y Control Module

STOP

EXT

MAN

spm

OUT

STROKE LENGTH

DISP

PosiFlow Sensor

Section A-A

Wiring side of

Connector

Red to Pin 2

Wht to Pin 1

Blk to center

Pin 5

E90496 Connector

Pump Connection 3

Thread PosiFlow

into MAVV of Pump

1 2 3 4 5 6

Sin comentarios

Walchem WebMaster Manual de usuario Pagina 3